Installation Guide

PREPARING LOCK FOR INSTALLATION

Step 3

If you drilled a hole in Preparation, use Slotted Barrel Extension U and use pliers to securely tighten

clockwise. If you did not drill a hole in Preparation, you can leave this pole removed.

Install Spindle C with

the holes side into the

base of the lock and

align the holes locate

in the 3 o’clock and

9 o’clock position.

Insert locking pin D

in to the hole as

shown above.

Peel paper layer OFF the

Adhesive tape and

prepare for installation.

Carefully bend the end

of the locking pin D with

a needle nose pliers.

Failure to bend the locking

pin and turn the handle freely

without obstruction will result

to malfunction.