Installation Guide

11
INSTALLING THE LOCK (INTERIOR)
Step 5 continued
LK
O
3
x
Pull the cable from the lock exterior
through the rectangular hole
underneath the positioning rods
and spindle.
Secure the hole above the spindle
with screws O .
Remove the position rods V and
replace them with screws O
Tighten clockwise until the mounting
plate is secure.
* If you have drilled a hole on the
top in Preparation, please secure
the hole with screw M1 or M2
depending on your door thickness.
Skip this if no hole was drilled in
Preparation.
*Secure top with M1 or M2
3
4
Secure with O1 or O2
Secure with O1 or O2
PM5 x 25mm
PM5 x 35mm
PM4 x 25mm
PM4 x 32mm
M1
M2
O1
O2