Installation Sheet
Fig. 4
Digital M-210 Deadbolt
Installation Instructions
M210 DCM 210
|
No. Part Name M210
2
1
3
4
5
Outside Body
Inside Body
Rubber Trim Plate
Morsed Strike
Spindle 40-55mm.
Spindle 30-45mm.
Machine Screw M4 x 50mm
Machine Screw M4 x 35mm
Wood Screw M4
Extra Code Tumblers (Red)
Extra Non-Code Tumblers (Blue)
Adjustable Deadbolt 2 3/8” - 2 3/4”
Tweezers
Hex Bolts
Brass Support Pin
6
7
8
9
10
11
12
13
14
15
1
1
1
2
1
1
2
2
4
1
2
1
1
2
1
Step 1: Change User Code/Combinaon (OPTIONAL)
To change user code/combinaon, see instrucons on reverse side.
Step 2: Prep Door for Installaon with Template (If door is preprepped with 2 1/8” hole, use Bonus M210EZ Mount Kit and Instrucons)
Place template (supplied) on door and fold along door’s edge.
Mark holes for 2 3/8” or 2 3/4” backset. Drill holes as instructed.
Step 3: Idenfy Door Handing
(The M210 is pre-handed for right-hand doors)
Right-Hand Doors – From exterior of door, hinges are on right-side (Fig. 1).
Le-Hand Doors – From exterior of door, hinges are on le-side (Fig. 2).
To change handing for le-hand doors, use a #1 phillips screwdriver to remove
two blue screws and cover plate from Outside Body (Fig. 3).
Move the handing pin from the right side of the outside body to the hole on the le side.
Replace plate and screws.
*Note: For M210DC – Inside Body must be handed opposite from Outside Body.
Step 4: Install Support Pin & Hex Bolts (Fig. 4)
Install Brass Support Pin (#15) into either hole on Inside Body.
Install/screw Hex Bolts (#14) into the top and boom of the Outside Body.
*Note: For M210DC -- No support pin is used on double combinaon locks.
Step 5: Adjust Deadbolt (if necessary) & Install
Adjustable Deadbolt (#12) is preset to 2 3/8” backset.
To adjust, li pin and slide to 2 3/4” (Fig. 5).
With arrow pointed UP, insert Deadbolt and secure with two (2) Wood Screws (#9).
14
1
2
4
5
6
7
8
9
10
11
12
13
14
15
3
3
Fig. 3
Fig. 5
INSTALLATION INSTRUCTIONS:
Inside Body M210DC:
DC= Double Combinaon
LIFT
SLIDE
Connued on Reverse Side
Handing Pin