Installation Guide

ManualsBrandsLockey ManualsHardwareE Digital Series Keyless Entry Single Cylinder Electronic Door Lever with Key Override and Remote

Table Of Contents

TEMPLATE

45 40 35

1-3/4" 1-9/16" 1-3/8"

Fit here on door edge

FOR BACKSET 70mm (2-3/4”)

FOR BACKSET 60mm (2-3/8”)

Mark Ø1" (25.4mm) hole at

center of door edge.

Ø54mm (2-1/8")

ELECTRONIC KEYPAD KNOB & LEVER LOCK

USER MANUAL

Limited Warranty Statements

1. Warranty

LockeyUSA warrants the Product to be free from defects in material and

workmanship for a period of 12 months from the original date of purchase.

If you discover a defect in the Product covered by this warranty, we will

repair or replace the item at our option using new or refurbished

components.

2. Exclusions

This warranty covers defects in manufacturing discovered while using the

Products as recommended by LockeyUSA rather than occurred by the act

of God, and damages caused by misuse, abuse, installation errors and/or

unauthorized modification.

3. Limited Liability

LockeyUSA will not be held liable for incidental or consequential losses or

damages to any act of God, misuse, abuse or unauthorized modification of

Product.

4. Reminder

Service requirement shall subject to the presentation of this warranty card

and defective parts to the manufacturer, LockeyUSA. The warranty card will

not be reissued if lost.

Product: LOCKEYUSA E-DIGITAL ELECTRONIC KEYPAD

KNOB & LEVER LOCK

Purchase Date : __________________________________________________

Name & Address of Distributor : _______________________________

____________________________________________________________________

_____________________________________________________________________

For Product Warranty Support, contact:

LockeyUSA Warranty Department

Phone: 888.395.0163

Email: support@lockeyusa.com or

warranty@lockeyusa.com

Attention : Please do not use the "electronic" screwdriver for installation.

Summary of content (7 pages)

PAGE 1
TEMPLATE Fit here on door edge 45 40 35 1-3/4" 1-9/16" 1-3/8" Mark Ø1" (25.4mm) hole at center of door edge. 1. Warranty Limited Warranty Statements LockeyUSA warrants the Product to be free from defects in material and workmanship for a period of 12 months from the original date of purchase. If you discover a defect in the Product covered by this warranty, we will repair or replace the item at our option using new or refurbished components. 2.
PAGE 2
KEYPAD ELECTRONIC LEVER & KNOB INSTALLATION INSTRUCTION The BACKSET is the distance between the center of cross bore and edge bore of the door. Adjustable latch fits both BACKSET of 2-3/8” (60mm) and 2-3/4” (70mm). Please follow the steps shown below for BACKSET adjustment. b Face the door from outside, the door is left handed if the hinge is on the left-hand side of the door, whereas the door is right handed if the hinge is on the right-hand side of the door. Door (Left Handed) a.
PAGE 3
7. Install Inside Mounting Plate 5. Install Strike a b Mounting Pass the IC wire through the wire hole on the Plate mounting plate and fix the mounting plate with screws. If outside lock assembly is lopsided, IC wire please loosen the screws to adjust it's position Screws and tighten the screws again. c a. Half-close the door to lay the latchbolt against the door frame. Mark the position of faceplate as an indication. Place the strike against the door frame and mark it's erimeter.
PAGE 4
9. Change Lever Handing a. Be sure the levers are unlocked. Insert the provided pin wrench into the small hole on the neck of lever and apply pressure to depress the catch and pull out the lever from the stem. Follow the same steps to remove interior lever and exchange the position of inside and outside levers.      1 2 3 4 5 6 7 8 9 0    b. Remove the cylinder from lever and insert it into opposite lever.
PAGE 5
■ Specification/ Function 6.User Code 1.Power 6V, four AA（1.5V）Alkaline batteries. 2.Low Battery 2-1 The batteries should be changed immediately once you see button1 flashes in red and hear 10 rapid beep sounds when press programming button. 2-2 All settings are retained in the memory and will not be affected even if the battery is completely dead. 2-3 The lock still can be operated by key even there is a power outage. 3.Illuminated Indicator 6-1 The preset User Code is 1234.
PAGE 6
■ Pass Code & Function Set up 12.Unlock the door 12-1 The lockset will be unlocked by key or pressing User Code on keypad from outside or by interior turn-button. 12-2 To unlock the door on the keypad, enter the User Code and then press the Programming/Enter button. 13.Lock the door The lockset will be locked by key or pressing Programming Button on keypad from outside or by interior turn-button. 14.
PAGE 7
■ Function Programming Programming Code (PC) Programming Code (PC) USER Code (UC) USER Code (UC) Add New User Code Enter PC Toggle Mute On/Off 1 Enter New UC Enter PC Remark : Up to 6 sets of User Code can be saved. User Code should be 4-10 digits in length. Delete An Existing User Code Enter PC 2 Enter PC 3 Enter New PC 9 Enter new disposable UC Remark : Disposable code will be no longer valid once being used.