Installation Guide

Programming Code (PC)
11

Function Programming
USER Code (UC)
Add New User Code
Enter PC
1
Enter New UC
Remark :
Up to 6 sets of User Codes can be saved. User Code should be 4-10 digits in length.
Delete An Existing User Code
Enter PC
2
Enter the UC
you want to
delete
Delete All User Codes At once
Enter PC
3
Remark : Auto-locking and Keypad locking function will be disabled when User Codes
are deleted. The lock can only be operated by the key during this time.
Change Programming Code
Enter PC
4
Enter New PC
Toggle Autolock On/O
Enter PC
5
Remark : The preset delay-time is 30 seconds, you can change the time by following
the instructions below.
Repeat the steps to cancel the Auto-locking function.
12
Programming Code (PC)
USER Code (UC)
Enter PC
6
Set Autolock Time Delay
Enter Seconds
(10~99)
Remark : 10-99 seconds delay-time available.
Toggle Mute On/O
Enter PC
7
Remark : Repeat same steps to turn sound On/O.
LED illumination is still functioning when it's in mute,
but there will be no warning alarm.
Enable/Disable All User Code
Enter PC
8
Create a disposable User Codes
Enter PC
9
Enter new
disposable
UC
Remark : Auto-locking and Keypad locking function will not work when User Codes
are disabled. The lock can only be operated with the key during this time.
Repeat the steps to enable the User Codes again.
Restore all preset lock settings
Press
R
Remark : Press “R” button for over 5 seconds, the programming will be complete after
you hear 3 long beeps.
Remark : Disposable user code is no longer valid once it’s been used.
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL
E-DIGITAL