Installation Guide
7
8
6V, four AA 1.5 v Alkaline batteries.
2-1 The batteries should be changed immediately once you see button1 ashing in red
and hear when pressing programming button.
2-2 All settings are retained in the memory and will not be aected even if the battery
is completely dead.
2-3 The lock still can be operated by key even there with a power outage.
3-1 ashes in green once when successful operation.
3-2 ashes green twice when successful programming.
3-3 ashes red 3 times when there is an operation error.
3-4 ashes red 5 times with code input error, the system will shut down
for system protection (Refer to 17).
3-5 ashes orange 3 times when system has been restored to default setting.
3-6 ashes orange slowly while in programming mode.
4-1 1 beep sound indicates a successful operation.
4-2 2 long beeps indicate successful programming
4-3 3 beeps indicate an operation error.
4-4 3 long beeps indicate that the system has been restored to default setting.
4-5 5 beeps with code input error, the system will shut down for system protection.
(Refer to 17)
4-6 10 rapid beeps indicate the battery is low.
5-1 The preset Programming Code is 0000. Please change it into a new one during rst
operation.
5-2 Only one Programming Code for function setting.
5-3 Programming Code is only for function setting, you can't unlock the lockset by
entering Programming Code.
5-4 Programming Code is 4-10 digits in length.
5-5 Programming Code can be changed anytime if needed.
1.Power
2. Low Battery
（ ）
3.Illuminated Indicator
4.Audible Indicator
5.Programming Code
Button1
Button1 in
Button1 in
Button1 in
Button1 in
Button1 in
10 rapid beep sounds
Specication/Function
6-1 The preset User Code is 1234. Please delete it and create a new one during rst
operation.
6-2 Up to 6 sets of User Codes can be saved.
6-3 User Code is only for unlocking the lock, without programming function.
6-4 is 4-10 digits in length.
6-5 can be deleted or added anytime if needed.
7-1 User Codes can be deleted individually. You can re-set the same number as code
even if it's been deleted before.
7-2 Programming Code is needed when deleting individual User Code.
8-1 All the User Codes can be deleted at once. You can still reset the same numbers as
codes even if they're deleted before.
8-2 Auto-locking and Keypad locking function will be invalid after deleting all User
Codes and the lock can only be operated by key. These functions will be restored
with new User Codes.
8-3 Programming Code is needed when deleting all User Codes.
9-1 Auto-locking and Keypad locking function will be invalid when User Codes are
temporarily disabled. The lock can only be operated by key during this time.
9-2 Repeat the programming steps again to restore the auto-locking, keypad locking
function and User Codes.
10-1 Disposable User Code is no longer valid once it has been used.
10-2 You can reset same number as Disposal User Code again.
10-3 Programming Code is needed when creating a Disposable User Code.
11-1 You can restore Preset Factory Code by pressing “R” button on the interior receiver
module when you forget Programming Code or you want to cancel all previous
setting.
11-2 After restore, the Programming Code would be 0000; the User Code would be
1234 again.
6.User Code
7.Delete Individual User Code
8.Delete All User Codes At Once
9.Temporarily Disable All User Codes
10.Create a Disposable User Code
11.Restore Preset Factory Code
User Code
User Code