Installation Sheet
3830/3835
Installation Instructions
Part
#
Part
Name
#
Included
DC Lock
# Included
1 Outside Body 1 1
2 Inside Body 1 1
3 Lever/Knob 2/2 2/2
4 Rubber Trim Plate 2 2
5 Strike Plate 1 1
6 Mortised Striker 1 1
7 Spindle 1 1
8 Allen Wrench 1 1
9 Machine Screw M4 x 30mm 2 2
10 Machine Screw M4 x 40mm 2 2
11 Machine Screw M4 x 50mm 2 2
12 Wood Screw M4 x 16mm 4 4
13 Extra Code Tumblers (Red) 1 2
14 Extra Non-Code Tumblers (Blue) 2 3
15 Adjustable Latch (2
3/8
” -2
3/4
”) 1 1
16 Support Pin 1 1
17 Tweezers 1 1
18 Hex Bolts 2 2
1
2
3
4
4
56
7
7
8
9/10/11
9/10/11
12
12
12
12
13 14
15
16
17
18
Important information about your lock:
1. When the door is closed, the system locks automatically.
2. From the inside, unlock using the knob or lever. For DC locks, unlock using the User Code, followed by
the knob or lever.
3. From the outside, unlock by pressing ‘C’ (CLEAR), followed by your User Code.
4. Your lock is equipped with a PASSAGE FUNCTION, allowing you to leave the door unlocked.
To enable the passage function:
Press ‘C’ (CLEAR), then ‘R’ (PASSAGE), then enter User Code.
To disable the passage function:
Press ‘R’ (PASSAGE), followed by ‘C’ (CLEAR).
To disable the passage function PERMANENTLY:
Remove the ‘R’ (PASSAGE) tumbler, leaving that slot empty.
IMPORTANT: Always press and hold the ‘C’ Button when removing and inserting Tumblers.
Refer to ‘How to Change Code’ instructions on reverse side.
R Tumbler
Installing your lock:
Step 1: Before installing, if you would like to change the user code,
follow instructions on reverse side.
Step 2: Prepare door for installation with template.
Place the supplied template on door and fold along the door edge.
Mark holes for 2 3/8” or 2 3/4” backset. Drill holes as instructed.
Step 3: Identify door handing, attach support pin (#16), attach hex bolts (#18)
Right Hand Doors- From exterior of door, hinges are on the right side.
If you have a Right Hand Door, screw support pin (#16) into position A.
Left Hand Doors- From exterior of door, hinges are on the left side.
If you have a Left Hand Door, screw support pin (#16) into position B.
Next, screw hex bolts (#18) into the top and bottom as shown.
Right Hand Doors Left Hand Doors
3830
Knob
3835
Lever
Support Pin
Position B
pg 1
Support Pin
Position A