Installation Guide

1. For Right Hand: Install the supplied SUPPORT PIN (Part No. 15) to “A” as Fig. 1.

2. For Left Hand: Install the supplied SUPPORT PIN (Part No. 15” to “B” as Fig. 2A.

3. Install/screw in Hex Bolts #17 into the top and bottom holes on the back side of

the outside combination body.

INSTALLATION INSTRUCTIONS FOR DIGITAL DOOR LOCK

MODEL 2835 LEVER HANDLE

lever handle 3 pcs

8. Allen wrench 1 pce

17. Hex Bolts 2 pcs

17 hex bolt

7 7

support pin

Fig. 2B

Allen wrench

lever handle

set screw

No. 2835

DIGITAL DOOR LOCK is equipped with “FOR BOTH RIGHT OR LEFT HAND” which the hinge is

installed on the right or left of the door on the sight from the out-door regardless of the opening

direction of the door. Determine the handing of the door and place handle on appropriately.

(Point handle toward hinge.) And tighten set screw with Allen wrench #8, as Fig. 2B.

2 pcs

3 pcs

NO. 2285

PAGE 1
INSTALLATION INSTRUCTIONS FOR DIGITAL DOOR LOCK MODEL 2835 LEVER HANDLE No. 2835 8. lever handle 3 pcs Allen wrench 1 pce 17 hex bolt 7 15 7 3 2 pcs 3 pcs 17 17. Hex Bolts 2 pcs DIGITAL DOOR LOCK is equipped with “FOR BOTH RIGHT OR LEFT HAND” which the hinge is installed on the right or left of the door on the sight from the out-door regardless of the opening direction of the door. Determine the handing of the door and place handle on appropriately. (Point handle toward hinge.
PAGE 2
spindle 10:00 - 4:00 position For door thickness from 1.5” up to 2.25” use full spindle #7 For door thickness for 1.125” to 1.75” cut spindle tab off. X off Making sure the spindle is the correct length according to the door thickness (if spindle is too long it will cause the lock to bind, it is too short it will not engage the lock mechanism. Insert it into the spindle hole of the front body and through the spindle hole in the latch bolt from the inside of the door.