User manual

Alternative Fitting - using the U bracket
1. Following steps (a) & (b) ‘Installing Battery’ section overleaf, remove the front cover of the Lock/ Alarm unit.
2. Position the red U bracket around the tubing onto which the unit is to be mounted. To protect the tube
from scratching wrap adhesive tape around tube first.
3. Slot the rear of the Lock/Alarm unit onto the U bracket legs. Make sure the fit between the U bracket and
the Lock/Alarm unit is tight before screwing together. If there is space between the tube and the
Lock/Alarm unit, pack out using adhesive tape.
4. Using the shorter of the screws provided, fix the unit onto the U bracket by locating the screws through
the holes in the metal chasiss in the Lock/Alarm and into the U bracket legs. Take care not to over tighten.
5. Following steps (c) & (d) in the ‘Installing Battery’ section, fit battery and replace the front cover of the unit.
USING THE COMPUTALOCK/ALARM
1. Guide the steel cable through the cable fixing plates on the item(s) you are protecting and finish with
the end of the cable back at the Lock/Alarm unit.
2. Raise the hinged flap which covers the lock hole on the front of the Lock/Alarm unit (You may need to
release the red cable clamp first in order to lift the flap). Insert the steel end of the cable into this
hole (make sure that it goes in all the way - you may have to use gentle force to do this when the
product is new) and turn the key to lock it in position - you have just locked the cable and set the alarm.
3. Any excess cable can be wrapped around the body of the Lock/Alarm unit and clamped tight using the
red cable clamp. Alternatively, the extra cable can be wrapped around a solid object eg. a post, before
being locked into position in the main unit.
4. To test the alarm prior to use turn the key to the locked position without inserting the cable into the lock
- the alarm siren should sound within a few seconds. If it doesn’t then you should change the battery
REPLACEMENT PARTS
Keys: A replacement key service is available in certain countries. For security reasons, keys will only be issued
to users who have proof of purchase and have logged their key number using the key registration form
enclosed, or via the website www.lockalarm.com. Once you have registered, in the event of key loss, the
manufacturer will endeavour to supply a replacement key (a charge will apply).
Cables: Should your cable become damaged, a replacement may be available (a charge will apply). Contact
the manufacturer via the website www.lockalarm.com for availability and charges.
***TROUBLESHOOTING***
Alarm doesn’t sound or only makes a “clicking” sound when activated
Check you have a high quality Alkaline battery installed (eg. Duracell or Energizer). Check battery life.
When key is turned with the cable inserted in lock hole the alarm sounds
Ensure cable is inserted all the way into the lock hole. Sometimes, particularly when new, the cable requires
gentle force to fit into hole. You may also need to hold cable in lock hole at the same time as turning the key.
STILL EXPERIENCING DIFFICULTIES INSTALLING OR USING YOUR COMPUTALOCK/ALARM?
Email [e-mail] or check the website www.lockalarm.com for more troubleshooting hints.
Alternatively, contact one of the addresses detailed above.