Install Instructions

Installation & Operation Manual

6 System piping (continued)

NOTICE

The piping will not support the weight of the water heater circulator pump. Do not attempt to support

the weight of the water heater circulator pump with the piping or its accessories. Refer to the pump

manufacturer’s installation instructions. Failure to comply could result in severe personal injury, death, or

substantial property damage.

⚠ CAUTION

FLOW CHECK

VALVE (TYPICAL)

EXPANSION

TANK

THERMOMETER

COLD WATER

SUPPLY

HOT WATER

SUPPLY

BUILDING

RETURN

DRAIN

TEMPERATURE

& PRESSURE

RELIEF VALVE

(TYPICAL)

FLOW

SWITCH

WATER

HEATER

CIRCULATOR

STORAGE

TANK

WATER

HEATER

UNION

(TYPICAL)

BALL VALVE

(TYPICAL)

MIXING VALVE

Y-STRAINER

DIR #2000570320_000

BUILDING RECIRCULATION FILTER

(IF REQUIRED SEE START-UP SECTION)

Figure 6-4 Single Heater - Single Tank

Please note that these illustrations are meant to show system piping concept only, the installer is responsible

for all equipment. The installer must follow all manufacturer’s instructions for each system component. The

installer is responsible for compliance with local codes.