User Guide

User’s Information Manual
1 Maintenance schedule
5
 WARNING
Follow the maintenance procedures given throughout this manual. Failure to perform the service and
maintenance or follow the directions in this manual could result in damage to the appliance, resulting in
severe personal injury, death, or substantial property damage.
Service technician
(see the Solution Installation and Service
Manual)
General:
• Address reported problems
• Inspect interior; clean and vacuum if
necessary
• Check for leaks (water, gas, flue)
• Examine venting system
• Check system water pressure/
system piping/expansion tank
• Check control settings
• Check wiring and connections
• Flame inspection (stable, uniform)
• Check flue gas passageways
• Inspect and clean the burners
• Perform start-up, check-out and
performance verification per
Section 6 - Startup of the Solution
Installation and Service manual
If combustion or performance
indicate need:
• Clean heat exchanger
• Remove and wash burners
ANNUAL START-UP
Owner maintenance
(see pages 6 - 7 for detailed instructions)
Daily
• Check appliance area
• Check pressure/temperature
gauge
Monthly
• Check vent piping
• Check relief valve
Periodically
• Test low water cutoff (if used)
• Reset button (low water
cutoff)
Every
6 months
• Check appliance piping (gas
and water) for leaks
• Operate relief valve
End
of season
months
• Shut appliance down (unless
boiler used for domestic hot
water)