Smart System User Guide

9
5 Fault Log screen
Figure 5-1_Fault Log Screen
The Fault Log Screen provides historical data about the
operation of the SMART SYSTEM. Click on the Fault Log
tab along the top of the Main Screen window (FIG. 1-1,
page 4). A window will appear with the status of numerous
counters and lists of the most recent events (FIG. 5-1 above).
Included are details of the control board serial number,
software version, default parameters, production date, and
last service date. The last 10 lockouts are listed (a lockout is
an event that causes the burner to shut off). In addition, the
number of hours the control has operated in various states is
shown, as well as the number of successful and failed ignition
attempts.
The total number of occurrences of certain faults are also
stored in the control and shown on the left side of the screen.
The column on the right shows the total occurrences since
the control was built. The column on the left shows the total
occurrences since the table was reset. Press the Reset Service
Reminder button at the bottom of the window to clear the
totals in the column on the left. This will also clear the last 10
lockouts. Note that the Lockouts section will not clear without
a disconnect and reconnect of the software after the Reset
Service Reminder is clicked.
PC Program Instructions