Owner manual

DS-3000U DS3000 User Guide
Loadstar Sensors, Inc.
Page: 17 / 48 033-01419 Rev. 4
7 QUICK PROGRAMMING HOW-TO TIPS
7.1 How to change the displayed decimal point location
1. Press the down button (bottom right) and holding it down, press enter (bottom left).
2. Now release the down button while continuing to hold down enter.
3. While continuing to hold enter press up (top right) or down (bottom right) to select your desired
decimal point location. The current decimal point location is illuminated on the display while you
continue to hold down the enter button.
4. Release enter when the decimal point is at the desired position. The display will retain this new
decimal point selection until changed again, or reset to the factory default.
7.2 How to reset or TARE the current displayed value to zero?
1. Press and hold the enter button until the display shows tare and all the decimal points (for all
the currently active sensors) illuminate. Releasing the button will now tare all the connected and
active sensors.
7.3 How to display the load from only sensors I choose?
1. Press and hold menu until “Enter Pass” and “000000” appear on the display
2. Press the up or down keys to select the programming mode password (default is 000001)
3. Press enter
4. You are now in programming mode at the dsplay prompt. Notice the decimal points are flashing
for inactive ports, and solid on for active ports.
5. Press down, one time to the disp 1 menu. Press enter to enable or disable this port from
being displayed. It is displayed if the decimal point corresponding to the port is illuminated, it is
NOT displayed if the port is extinguished.
6. Press down as above for disp 2, disp 3, disp 4 leaving only the ports you want illuminated,
or enabled.
7. Press up to dsplay, and confirm that the decimal point is not illuminated on the ports you’ve
disabled.
8. Press mode until the run entry
9. Then press enter to return to run mode. Your display will now only show the sum of the ports
you’ve chosen.
7.4 How do I tare only one connected sensor?
1. Press and hold menu until “Enter Pass” and “000000” appear on the display
2. Press the up or down keys to select the programming mode password (default is 000001)
3. Press enter
4. You are now in programming mode at the dsplay prompt. Press mode until you reach the tare
menu .page
5. Press down, to the menu entry corresponding to the sensor you want to tare- from sensor 1 ->
tare 1 to sensor 4 -> tare 4.