User's Manual

25 LS420 Universal User Manual V2.91 2003-01-21.doc
Do not unscrew the white nylon hex bolt of the antenna.
Do not unscrew the four round topped hex bolts
Do not cut any wires
Step 3.
Unscrew the two Phillips head screws about ¼ inch. Do
not fully unscrew or remove these screws to avoid destroying
the seal in which they are set.
Step 4. Carefully cut the silicone seal all around the base of the
box where it meets the link.
Step 5.
Carefully separate the box from the link by inserting a
flat head screwdriver in the notch where the box meets the link
and turning. Do not damage the wires that run between the link
and the box.
Step 6.
Gently pull
on the connecting
wires to disconnect
the plug in the bat-
tery box.
Avoid all contact with
the tiny white inter-
rupter switches.
Step 7.
To remove the batteries, always remove the
battery closest to the indicator light first, the mid-
dle battery second, and the battery furthest from the
indicator LED last. The batteries can easily be re-
moved by hand. Gently apply pressure in the direc-
tion of the negative pole while lifting out the positive
pole.
Tip:
Alternative method: use a very small, flat head
screwdriver. Gently place the tip of the screwdriver
against the top of the negative pole of the battery closest to the indicator light and, using the
side of the box for support, lift the battery up until it can be grasped and removed by hand.
Indicator light
+
The battery
closest to
the indicator light is
removed first.
The screwdriver
is applied to the
negative contact
only.
+
+
Notch