User's Manual Part 2
36
36
The GS820 System
The GS820 System
3.5
3.5
Menu System
Menu System
There are eight basic menus (level one) used to
program, consult and control the GS820 system; 1)
P
ARTS OF LINES; 2) CRANE RIGGING; 3) DISPLAY
SETTINGS; 4) INSTALLATION; 5) SYSTEM DIAGNOSTIC; 6)
SYSTEM LIMITS; 7) TARE; 8) INFORMATION.
The basic menus include nested sub-menus (level
two and three) designed to address specific tasks
including adjusting values, choosing from lists and
following “wizards” through step by step processes.
3.5a Menu Numbers
The basic menus (level one) are numbered one
through eight. Level two menus are lettered
alphabetically. Level three menus are numbered.
Menus can also include numbered lists.
3.5b Menu Navigation
From the operation display press Menu/Enter to
see the eight basic menus (level one). Use the
selection button to select a menu. Press Exit to
leave a menu and return up one level. Press Next
to move to the next page within a menu; press
Back to move to the previous page within a menu.
Use Up and Down to modify numeric values and to
move through a list of choices.
3.5c Password Protection
The submenus of menu 4) INSTALLATION are
protected by a password by default. Password
settings can be adjusted in menu 4H) P
ASSWORD
SETTINGS. If the user password is forgotten, it can
be changed as long as the administrator password
is known.
3.5d Menu Layout
The menus accessible to the operator without
password protection under the default factory
settings are listed below.
1) PARTS OF LINE
2) CRANE RIGGING
3) DISPLAY SETTINGS
4) INSTALLATION
5) SYSTEM DIAGNOSTIC
5A) SYSTEM SENSORS DIAGNOSTIC
5B) RADIO NETWORK DIAGNOSTIC
5B1) RADIO NETWORK
5B2) LAST SENSORS RECEIVED
5B3) SEARCH FOR SENSORS
5B4) BIT ERROR RATE TEST
5C) LOCKOUT DIAGNOSTIC
5D) DISPLAY DIAGNOSTIC
5E) DIGITAL INPUT DIAGNOSTIC
6) SYSTEM LIMITS
7) TARE
8) INFORMATION
Figure: Basic menus (level one)
Forgotten password? Call
LSI
LSI technical support
(Houston, TX) at 888 819 4355.
WARNING!
System limits are not
monitored when the display is in menu
mode. DO NOT operate the crane in menu
mode. DO NOT navigate system menus when
operating the crane.
!
!