User's Manual Part 2
GS820 MEU OUTLIE
GS820 MEU OUTLIE
51
51
1) PARTS OF LINE
2) CRANE RIGGING
3) DISPLAY SETTINGS
1) Weight units
2) Display language
3) Backlight mode
4) Wind speed units
4) INSTALLATION
4A) SENSOR LIST
4A1) SENSOR TYPE AND RADIO IDENTIFICATION
NUMBER
1. Configuration select (automatic, manual)
2. Configuration number
3. Start up page
4B) SENSOR CALIBRATION
4B1) AUTOMATIC VALUE CALIBRATION WIZARD
4B2) MANUAL PARAMETER ADJUSTMENT
4B3) RESET SENSOR PARAMETERS
4C) RADIUS SETTINGS
1) Boom length
2) Slew offset
3) Height offset
4) Boom deflection
5) Boom top length
6) Boom top offset
7) No load deflection
8) Jib offset
9) Lattice extension offset
10) Jib mounting point perpendicular
11) Jib mounting point parallel
12) Main hoist
12A) Jib length
12B) Luffing jib length
12C) Lattice extension length
12D) Manual length
12E) Sheave head length perpendicular
12F) Sheave head length parallel
12G) Sheave radius
12H) Deduct
13) Auxiliary hoist
13A) Jib length
13B) Luffing jib length
13C) Lattice extension length
13D) Manual length
13E) Sheave head length perpendicular
13F) Sheave head length parallel
13G) Sheave radius
13H) Deduct
14) Auxiliary hoist 2
14A) Jib length
14B) Luffing jib length
14C) Lattice extension length
14D) Manual length
14E) Sheave head length perpendicular
14F) Sheave head length parallel
14G) Sheave radius
14H) Deduct
15) Auxiliary hoist 3
15A) Jib length
15B) Luffing jib length
15C) Lattice extension length
15D) Manual length
15E) Sheave head length perpendicular
15F) Sheave head length parallel
15G) Sheave radius
15H) Deduct
16) Auxiliary hoist 4
16A) Jib length
16B) Luffing jib length
16C) Lattice extension length
16D) Manual length
16E) Sheave head length perpendicular
16F) Sheave head length parallel
16G) Sheave radius
16H) Deduct
17) Auxiliary hoist 5
17A) Jib length
17B) Luffing jib length
17C) Lattice extension length
17D) Manual length
17E) Sheave head length perpendicular
17F) Sheave head length parallel
17G) Sheave radius
17H) Deduct
4D) CHART SETTINGS
1) Rated capacity indicator
2) Crane capacity chart interpolation
3) Out of charts default working load limit
4) Enable start section
5) Enable stop section
6) Retracted boom length tolerance
7) Intermediate boom length tolerance
8.
8.
GS820 MENU OUTLINE
GS820 MENU OUTLINE