User's Manual

MAITEACE

4.1

Replacing the Sensor

Battery

1. Unscrew the two allen screws about a quarter

of an inch.

2. Insert a flat bladed screwdriver in the battery

cover notch to pry the box away from the

mounting plate. The silicone seal may cause

some resistance.

4. Remove the battery by hand.

5. Remove the remaining silicone from both the

box and the mounting plate.

6. Install the new battery: insert the positive end and

then push in the direction of the positive pole.

8. Apply a non-corrosive RTV silicone all around

the edge of the mounting plate to create a new

seal without bubbles or breaks.

9. Reposition the box over the mounting plate and

screw in the hex screws. Do not over-tighten.

MAINTENANCE

1/4 in.

Hex key 5/32 in.

Flat bladed

screwdriver

New high quality “D”

cell battery: 3.6 V lithium,

or alkaline

Figure: Remove the sensor box from the mounting plate

* Actual battery life will vary greatly depending on

the application, the frequency of use, the age and

quality of the battery etc.

RTV non-corrosive

silicone

Figure: Install the new battery

Figure: Apply non-corrosive RTV silicone

IMPORTANT!

Protect the interior of the

sensor from dirt and humidity at all times.

Note: A 3.6 volt lithium “D” cell battery will provide

about two years of battery life, while an alkaline “D”

cell battery will provide less than one year of

battery life*.