User's Manual

ISTALLATIO
ISTALLATIO
5
5
2.1
2.1
Display GS320
Display GS320
2.1a Mounting Bracket
1. Determine the mounting location; the display
may be installed either inside or outside the
cab. It can be mounted on the dash, on a
sidewall, or on the ceiling of the cab. To ensure
reliable radio communication between wind
speed sensor and the GS320, the antenna
should not be in contact with metal and
should have a direct and clear line of sight
to the sensor antenna. The mounting bracket
requires a flat surface of at least 2.5 inches in
diameter on both sides and where the back of
the surface is accessible in order to tighten the
nuts.
2. Drill 1/4 inch boltholes through the mounting
surface with a 1/4 inch bit following either the
two, three, or the four holes configuration.
3. Install the display with bolts. Add washers and lock
nut behind the mounting surface and tighten
sufficiently (bolts, nuts and washers not included).
4. Loosen the wing nut of the bracket arm to adjust
display orientation to facilitate viewing by the
operator and then tighten it back up.
2.
2.
INSTALLATION
INSTALLATION
Cab mounting
surface
www.loadsystems.com
w
ww.lo
a
d
s
y
s
t
e
ms
.
c
o
m
GS320
Wind Speed Indicator
GS320
GS320
Wind Speed Indicator
mph
m/s
Status Alarm
Low
Batt
Set
Limit
Wing
Nut
Figure: Display mounting bracket footprint. Not to scale.
Figure: Install the display and adjust orientation
www.loadsystems.com
www.loadsyst
ems.com
GS320
Wind Speed Indicator
GS320GS
320
Wind Speed Indicator
mph
m/s
Status Alarm
Low
Batt
Set
Limit
6.19
4.70
1.37
Adjustable
Ram-Bracket
with dual ball joints.
Part number: LB002B
Rugged
aluminium
enclosure
Two way radio
system
Waterproof
design
Field replaceable
antenna
Part number: TA008
www.loadsystems.com
4
4
4
4
.7
0
70
w
ww.
l
oa
d
s
y
stems.com
GS320 Wind Speed Indicator
GS320GS320 Wind Speed Indicator
mph
m/s
Status Alarm
Low
Batt
Set
Limit
2.20
6.49
3.70
8.83
2.44
Figure: Display GS320
Figure: Display dimensions (inches). Not to scale.
0.750 0.750
0.906
ø0.218
ø2.5 in. min.
flat surface
120° TYP
0.594
0.594
IMPORTANT! Do not crack or puncture
the membrane fascia. The GS320 display is
splash and rain proof. Waterproofing depends in
part on the integrity of the membrane.
IMPORTANT! Do not power wash the
display. The GS320 display is not designed to
withstand high-pressure washing devices that
can erode the membrane fascia seal or create
fissures in the membrane fascia. Power washing
the display voids warranty coverage.
!
!
Note: If the nuts are on the outside of the cab,
caulk with silicone between the washers and the
cab to prevent water entry.
WARNING! Installation must be made in
compliance with
LSI
LSI instructions and using
supplied components only. Failure to install
all parts, or replacing parts or components
with parts or components not supplied by
LSI
LSI, may lead to system failure, serious
injury or death.
!
!