User's Manual

8
8
The GS22X System
The GS22X System
3.1
3.1
GS22X Installation
GS22X Installation
It is recommended to install the receiver on the right
side or left side of the cab, usually on the same side
as the wind speed sensor. The best positioning
would ensure line of sight in most boom position. If
line of sight is not always possible, position
optimisation could help improve the radio link, which
improves battery life. If possible, do not hide the
receiver behind metal structure.
3.1a Antenna Position
For optimal performance the antenna should be
positioned on its side such that it is parallel to
the sensor antennas (but not pointing directly to or
directly away from them).
1. Adjust the antenna position with the articulating base.
2. The antenna should have 5 inches of clear
space all around it.
3. The antenna should have an unobstructed line of
sight to all sensor antennas at all boom angles.
3.1b Power Supply and Lockout
Connection
3.1c Wiring
Table: Wire description
Wire Color Description
Red . . . . . . . . . . . . Power supply, 9 to 36 volts
Black . . . . . . . . . . . . . . . . . . . . . . . . . . Ground
Blue . . . . . . . . . . . . . . . . . . . . CAN bus ground
. . . . . . . . . . . . (not required on most CAN bus)
Green . . . . . . . . . . . . . . . . . . . . . . . . . . CAN-H
White . . . . . . . . . . . . . . . . . . . . . . . . . . . CAN-L
IMPORTANT! Do not power wash the
GS22X. The GS22X is not designed to
withstand high-pressure washing devices that
can erode the membrane fascia seal or create
fissures in the membrane fascia. Power washing
the display voids warranty coverage.
!
!
WARNING! Installation must be made in
compliance with
LSI
LSI instructions and using
LSI
LSI
supplied components only. Failure to
install all parts, or replacing parts or
components with parts or components not
supplied by
LSI
LSI
, may lead to system failure,
serious injury or death.
!
!
3.
3.
INSTALLATION
INSTALLATION
Figure: GS22X dimensions. Not to scale.