User's Manual

GM085_ENG_rev.docx www.loadsystems.com 6
8. FCC and IC – Instructions to
the User
This equipment has been tested and
found to comply with the limits for a class
B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radiofrequency
energy and if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
In order to maintain compliance with FCC
regulations, shielded cables must be used
with this equipment. Operation with non-
approved equipment or unshielded cables
is likely to result in interference to radio
and TV reception.
IMPORTANT!
Changes or modifications to this
equipment not expressly approved by
the party responsible for compliance
could void the user’s authority to
operate the equipment.
FCC ID: QVBGS002 IC: 7076A-ICGS002
RF Exposure Warning:
This product complies with FCC/IC
radiation exposure limits set forth for an
uncontrolled environment. To comply
with RF exposure requirements, the unit
must be installed and operated with 20
cm (8 in.) or more between the product
and your body. This product may not be
collocated or operated in conjunction
with any other antenna or transmitter.
This device complies with Industry Canada
licence-exempt RSS standard(s).
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference, including
interference that may cause undesired
operation of the device.
This Class A digital apparatus complies
with Canadian ICES-003.