User's Manual

36
36
The GS820 System
The GS820 System
Program a sensor repeater
1. In menu 4I), select 4I3) S
ET UP SENSOR REPEATOR.
2. Select 1) S
ELECT REPEATER, press Enter to
modify and use Up and Down to program the
radio ID number of the sensor that will be the
repeater
and press Enter to confirm.
3. Select 2) S
ELECT SOURCE, press Enter and
program the radio ID number of the sensor that
will be the source
and press Enter.
4. Press “S
ET UP REPEATER” to save the new
network path. The following messages will be
displayed briefly:
“P
ARAMETERS SAVED CORRECTLY”
“C
OMMUNICATING WITH REMOTE SENSOR”
“CONFIGURATION SAVED SUCCESSFULLY”
5. Press Exit to return to the operation display.
Clear a sensor repeater
1. In menu 4I), select 4I2) R
EPEATOR LIST. Menu 4I2
details the last repeater programmed. When no
repeater has been programmed, “NO REPEATER
SET UP
” message is displayed.
2. Select a repeater in the list and press “R
EMOVE
REPEATER” to shut down the repeater
programmed. The following messages will be
displayed briefly:
“R
EMOVING NETWORK PATH”
“I
NITIALIZING NETWORK”
3. To shut down additional repeaters repeat step 1
and 2.
4. Press Exit to return to the operation display.
2.16d Wireless Sensor Update
It is possible to send a firmware update to a sensor
using the GS820 (menu 4I4) INSTALL SENSOR
UPDATE). For more information on installing a
sensor update please contact
LSI
LSI.
Figure: Program a sensor repeater
CAUTION! Test all system functions after
setting up or removing a repeater. Shut off
and then restart the GS820.
!
!