User's Manual

50 Revision 2 GM550 v1043 FCC-IC.doc
Load Pin Transmitter GS001
Step 1. Determine the transmitter mounting position.
a. The load pin and transmitter pigtails must connect easily without stretching or
kinking at all boom angles and working conditions. The jumper cable may be used
between the load pin and transmitter to increase transmitter placement options.
b. There must be direct unobstructed line of sight from the transmitter to the display
(this may not be required on cranes with a maximum boom length less than 100’).
c. The transmitter antenna must not be in contact with any metal object.
Step 2. Weld the mounting blocks where required.
WARNING! Do not weld in proximity to LSI sensor/transmitters.
Step 3. Mount the load pin transmitter on the mounting blocks.
↑
Load pin
Single part block
Figure: Load pin LP011, LP015, or LP026 –
installation on a single part block
Wedge socket