User's Manual

48 Revision 2 GM550 v1043 FCC-IC.doc
Wireless Wind Speed Sensor GS020
Includes:
Wind speed sensor/transmitter assembly
Mounting rod
Mounting screw
Mounting screw washers (2)
Installation
Unscrew the mounting rod from the wind speed sensor transmitter
assembly.
Select the welding point for the mounting rod. The mounting rod must
be installed on the same side of the boom as the cabin mounted
display, perpendicular to the boom at the highest point possible.
The sensor/transmitter assembly must swing free of any obstruction,
No object should interfere with the wind cups,
There must be a clear and unobstructed line of sight between the sensor/transmitter antenna and
the cabin mounted display unit,
The transmitter antenna must not contact any metal object.
WARNING! Do not weld in proximity to LSI sensor/transmitters.
Weld the mounting rod to the boom at the selected point.
Screw the sensor/transmitter assembly to the mounting rod with the mounting screw. Note that
washers should be screwed one to each side of the brass bushing of the sensor/transmitter
assembly.
Mounting rod
LS020 wind speed
sensor/transmitte
r
Boom tip
Weld point
Sheave head
Boom tip
LS020 speed
wind sensor/
transmitter