User's Manual Part 2

GS550 UNDERHOOK
21
ChApTEr 8: CErTiFiCATiON NOTES
8: CErTiFiCATiON NOTES
8.1 FCC & IC – Instructions to the User
This equipment has been tested and found to comply with
the limits for a class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference via one or
more of the following:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from the circuit to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
In order to maintain compliance with FCC regulations,
shielded cables must be used with this equipment.
Operation with non-approved equipment or unshielded
cables is likely to result in interference to radio and TV
reception.
FCC ID: QVBGS550 IC: 7076A-ICGS550
This product complies with FCC/IC radiation exposure
limits set forth for an uncontrolled environment. To
comply with RF exposure requirements, the unit must
be installed and operated with 20 cm (8 in.) or more
between the product and your body. This product may not
be collocated or operated in conjunction with any other
antenna or transmitter.
This device has been designed to operate with the
antennas listed below, and having a maximum gain of
2.0 dB. Antennas not included in this list or having a gain
greater than 2.0 dB are strictly prohibited for use with this
device. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more
than that permitted for successful communication.
antenna lIst
LSI-Robway P/N: TA001
Description: 1/4 wave monopole
MFG Linx Technologies
P/N ANT-916-CW-QW
LSI-Robway P/N: TA008
Description: 1/2 wave dipole
MFG: Nearson
P/N: S467AH-915S
RF Exposure Warning:
ChANgES Or mOdiFiCATiONS TO ThiS
EquipmENT NOT EXprESSLy ApprOvEd
By ThE pArTy rESpONSiBLE FOr
COmpLiANCE COuLd vOid ThE uSEr’S
AuThOriTy TO OpErATE ThE EquipmENT.
CAUTION
ThE prOTECTiON wiLL BE impAirEd iF
ThE mATEriAL ANd EquipmENT ArE uSEd
iN A mANNEr NOT SpECiFiEd By ThE
mANuFACTurEr.
WARNING
ThE ip OF ThE diSpLAy COrrESpONdS TO
65 ANd ThE uNdErhOOK iS 66.
CAUTION