Product Manual
DAWS MANUFACTURING COMPANY, INC. 8811 GROW DR PENSACOLA, FL 32514 (800) 366-8269
C s -n!
www.DawsBetterBuilt.com
7
INSTALLATION OF CLAMP-ON BUCKET ACCESSORIES (SEE FIGURE 1 BELOW)
1. Always check the tractor/loader to make sure it is in good working condition.
2. Before clamping, ensure the Gripper “T” Handle(s) is clear of all loose debris prior to tightening.
3. Unscrew Gripper “T” Handle(s) to allow enough space to slide the attachment over the bucket.
4. Slide the clamp-on attachment all the way on. The front edge of the bucket should be completely
inserted into the attachment with no extra space left in front of the bucket edge.
5. Tighten the Gripper “T” Handle(s) until the attachment is securely clamped to the bucket.
****RECOMMENDED USE OF STABILIZER BAR ATTACHMENT WHEN USING TWO OR MORE FORKS****
********************************************************************************
WARNING! Use of the correct stabilizer bar is imperative.
********************************************************************************
TO ADJUST TINE WIDTH ON PALLET FORKS: Raise the bucket slightly (about 12 inches) and loosen the
Sure Grip Contact Pad(s). Slide the individual fork(s) to the correct width for the load being moved. When the
correct width setting is achieved, tighten Sure Grip Contact Pad(s) securely.
TO ADJUST TINE WIDTH ON PALLET FORKS WITH STABILIZER BAR: Follow steps listed above.
Ensure stabilizer bar is completely seated over the Rollback Stabilizer Mast. Tighten both end handles on the
Stabilizer Bar.
DANGER!
DO NOT operate the tractor if the attachment is not securely fastened to the bucket. Always check and tighten
the attachment before each use. If loose, your load and attachment can come off the bucket creating a dangerous
situation that could lead to serious injury or even death.
INSTRUCTIONS