Product Manual

TO LOAD
TO UNLOAD
TO REMOVE LH2000
6 7
Untie Travel Straps.
Pull Dragsheet from Roller and
lay on Bed Floor.
Always leave 3-4 wraps on the
roller.
Load truck.
Open tailgate and spray lubricate
the Bearings.
Re-tighten bumper strap.
Insert Crank Handle into Drive
Slot on Roller.
Start cranking clockwise to roll
up Dragsheet and unload Truck.
(If handle is too close to the truck,
readjust roller position until handle
just clears the truck.)
Always clean Bed of all materials
before next load.
Loosen the two long straps and
unhook the bumper strap.
Remove LOADHANDLER
®
.
TO STOP ROLLER TURNING WHILE
DRIVING WITH A HIGH LOAD
Press the two Velcro straps together to make one long
strap.
Feed one end of this long strap through the drive slot.
Wrap the strap around the bearing bracket projecting
from the rear of the tailgate.
This will keep the roller from turning while you are
driving with a high load and stop the drag sheet from
billowing behind the truck.
It is also a good place to keep the straps when you are
loaded. You'll know where they are!
1.
2.
3.
4.
IF YOUR LOAD DOESN'T MOVE, STOP!
Check to see if the load is "LOCKED" around the wheel
wells (see note on page 1). Call a product specialist at
[phone] for assistance if desired.
Pull the strap and tight press the ends of the strap
together to secure them in place.