Product Manual

2 11
INSTRUCTIONS
Check Parts List
1 Main Roller with Dragsheet
2 Bearing Brackets
1 Crank Bar
1 Bag Fasteners
2 Bolts 3/8" x 1 1/2"
4 Washers 3/8"
2 Nuts 3/8"
4 Shaft Collars
2 Rear Brackets
1 Handle Assembly
2 Plastic End Caps
4 Round Head Screws #8 1"
4 Square Nuts #8
Remove the Plastic End Caps from each end
of the Roller.
Slide one Shaft Collar onto each end of the
Roller.
Slide a Bearing Bracket onto each end of the
Roller. (Make sure the long leg of the Bearing
Bracket is toward the front of the truck as
shown).
Slide a second Shaft Collar on each end of the
Roller and leave loose. (Insert the Shaft Collar
Screws and Nuts but do not tighten them yet.)
Re-cap each end of the Roller with the Plastic
End Caps.
Slide the Rear Brackets onto the Bearing
Brackets as shown and loosely attach them
with the Bolts, Washers and Nuts as shown.
1.
2.
3.
4.
5.
6.
MAIN ASSEMBLY
TO FRONT OF TRUCK
SPRAY LUBRICANT HERE
LEAVE 1/4" BETWEEN COLLARS AND BEARINGS
ADJUSTMENT HOLES
SPRAY LUBRICANT HERE
DRIVE SLOT ON DRIVER'S SIDE (OUTSIDE EDGE OF TAILGATE)
STRAPS OMITTED FOR CLARITY
TAILGATE
LH 2000 & LH 20000M
AFTER ASSEMBLY