Product Info
Table Of Contents
- 1. Introduction
- 2. APPLICABLE MODULE
- 3. Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4. Compliant/Allowable Tx Power Settings
- 5. Allowable Antennas to use with the Radio Module
- 6. Antenna Placement and RF Safety
- 7. Simultaneous Transmission with other Integrated or Plug-in Radios
- 8. Module May Not Be Installed by End Users
- 9. REQUIRED LABELING ON THE OUTSIDE OF THE HoST
- 10. REQUIRED LABELING ON THE MODULE
- 11. REQUIRED REGULATORY WORDING FOR End USER MANUAL / INSTALLATION MANUAL
- 11.1 FCC Requirements for End User Manual / Installation Manual
- FEDERAL COMMUNICATIONS INTERFERENCE STATEMENT
- FCC RF Exposure Requirements:
- 11.2 Industry Canada Requirements for End User Manual / Installation Manual
- Industry Canada Statements
- Radiation Exposure Statement
- Déclaration d'exposition aux radiations
- 12. OEM Integrator Checklist
Open-Q 835 µSOM Modular Certification TechNote77 OEM Integrator Guide
Rev. 1.1
7
Copyright Intrinsyc Technologies Corporation
The FCC requires a logo signifying emission compliance on the outside of the host system.
The OEM integrator is responsible to perform FCC Part 15 Class B digital emissions testing
on the end system with the radio Module installed. The FCC logo below should not be
affixed unless the OEM integrator has obtained the necessary Part 15 approval, e.g., self-
declaration of conformity.
If the host system is approved to FCC Class B digital emissions limits under a grant of
certification issued by a TCB, the FCC ID number shown on the grant should be used on the
label instead of the FCC logo below.
Also see https://www.fcc.gov/logos.
A certified modular has the option to use a permanently affixed label, or an electronic label
(Refer to FCC KDB 784748 D02 e labeling for e-labelling guidance). All modules without
an integrated display on the module must be labelled with a module’s FCC ID - Section
2.926.
9.2 Industry Canada Labeling Requirements on the Outside of the Host
End Product Labeling
The final end product must be labeled in a visible area with the following for the
Open-Q 835 μSOM: Contains IC: 9049A-ITCOQ835S.
Plaque signalétique du produit final
Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante:
Open-Q 835 μSOM: Contient des IC: 9049A-ITCOQ835S.