Installation Guide

www.ihomeangel.com Page: - 4 - / 4
Step C2: Raise the canopy (G) through screw collar loop (I) and screw the collar loop (I) to a proper position by measuring.
Unscrew threaded ring (H) from screw collar loop (I) and remove the canopy (G). In this way, you would know the
Proper position on which collar loop it should be located.
Note: The canopy (G) should be snug against the ceiling and the collar loop (I) should be screwed enough
threads (no less than 6 threads )over the threaded nipple (C) for more secure hanging .If not, adjust the collar
loop (H)on the single bar assembly by screwing the collar loop (I) in or out of the single bar (E) until the
length is achieved.
Step C3: Slip the threaded ring(H) over the chain(K),then do the same with the canopy(G)
Step C4: Open the quick link(J)，attach the quick link (J) to connect the loop (I). Close the quick link(J)
Pass the wires through screw collar loop(H) to the top of nipple(E) and gently pull till snug.
Step C5: If needed, cut off the wires length of fixture.At this point, the remaining wire length measured from the top of single
bar(B) is at least 6".
Step C6: Make wire connections
Connect wires as below wires connecting shown. TAKE NOTE OF YOUR COLOR OF FIXTURE ,NEVER CONNECT
WIRES TO GROUND WIRES
Connect ground wire according to below chart Connect wires according to below chart
Twist plastic wire connector(D) until wires are tightly joined together,wrap each connector with approved electrical
tape for more secure connection, then carefully stuff all wires into the outlet box
Step C7: Raise canopy (G) to ceiling and secure canopy (G) in place by tightening threaded ring (H) onto collar loop (I)
Step C8: Adjust arms(N) to their proper positions
Install bulbs (not included) (Please do not exceed the maximum capacity recommended on the socket.)
6. Check everything is already installed properly, then you could turn on the light. Enjoy!
CLEANING
To clean, wipe fixture with a soft cloth. Do not use abrasive materials such as scouring pads or powders, steel wool
or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order replacement parts. All parts for this fixture can
be ordered from place of purchase. Be sure to use exact wording from illustration when ordering parts.
[phone]
Working hours : Mon - Fri 9:00 a.m. - 16:00 p.m. EST
[e-mail]