Installation Guide

www.ihomeangel.com Page: - 3 - / 4
must face to the down.
Step A3:Thread the collar loop (I) onto the nipple (C)
3. Make pre-installation
Step B1: By measuring, determine the correct number of links needed for proper hanging height. Using the chain pliers,
disconnect and discard the remaining chain.
Step B2: Slip orderly the post (M)and loop (L) along wires then thread onto the fixture body (O) till tight.
Attach the finial (P) to the bottom end of the fixture body (O), turning the Finial (P) till tight.
Step B3:Attach the quick link(J)to conect the chain(K) and the loop(L) on the trim(M)
Step B4: Carefully lace the wires through the chain (K)(every other link)and stop just before you reach the top of chain (K).
Gently pull the wires till snug .
4. Turn off power
Before you start to make installation, NEVER attempt any work without shutting off the electricity until the work is done.
A). Go to the main fuse, or circuit breaker, box in your home. Place the main power switch in the “OFF” position. B). Place
the wall switch in the“OFF” position
5. Make installation
Step C1: .Attach the single bar (E) to outlet box with mounting screws (B). The side of single bar marked "GND" must face out
+
1 850 296 2377
Working hours : Mon - Fri 9:00 a.m. - 16:00 p.m. EST
[e-mail]