Installation Guide

www.ihomeangel.com Page: - 2 - / 4
TOOLS REQUIRED (NOT INCLUDED):
Before doing assembly and installation please prepare the needed tools as below picture
PARTS TYPE & QTY INCLUDING:
(A) Hex nut (1)
(C) Nipple (1)
(E) Single bar (1)
(F) Green ground screw (1)
(G) Canopy (1)
(H) Collar ring (1)
(I) Collar loop (1)
(J) Quick link (2)
(K) Chain (1)
(L) Loop (1)
(M) Post (1)
(N) Arm (6)
(O) Fixture body (1)
(P) Finial (1)
ACCESSORIES & QTY ENCLOSED:
(B) Mounting screw (2)
(D)Plastic wire connector (3)
ASSEMBLY & INSTALLATION INSTRUCTIONS:
1. Carefully remove the fixture from the carton and check that all parts and accessories are included as shown in the
above illustration.
2. Make assembly
If the group of parts are not already assembled:
Step A1: Thread the single bar(E) onto nipple (C),
Step A2:Thread the hex nut (A)onto the nipple (C) till snug,.At this point need note that: the side of single bar marked "GND"
[phone]
Working hours : Mon - Fri 9:00 a.m. - 16:00 p.m. EST
[e-mail]