Installation Guide

[phone] Working hours : Mon - Fri 9:00 a.m. - 16:00 p.m. EST [e-mail]
www.ihomeangel.com Page: - 4 - / 4
Step C1: Remove the threaded ring (F) from collar loop(G).
Attach the single bar (C) to outlet box with mounting screws (B). The side of single bar marked "GND" must face out
Step C2: Pass canopy (E) over the mounted collar loop (G) then secure with threaded ring (F) to test the height .Unscrew
threaded ring (F) from collar loop (G) and remove the canopy (E).
Note: The canopy (E) should be snug against the ceiling and the collar loop (F) should be screwed enough
threads (no less than 6 threads )over the threaded nipple for more secure hanging .If not, adjust the height
of nipple and collar loop (G) until the desired height is reached. Remove the threaded ring (F) and canopy (E)
and place to the side.
Step C3: Slip the threaded ring(F) over the chain(I),then do the same with the canopy(E).
Step C4: Open the quick link(H)，attach the quick link (H) to connect the loop (G). Close the quick link(H)
Pass the wires through screw collar loop(G) to the top of nippleand gently pull till snug.
Step C5: If needed, cut off the wires length of fixture.At this point, the remaining wire length measured from the top
single bar(C) is at least 6". StepC6: Make wire connections
Connect wires as below wires connecting shown. TAKE NOTE OF YOUR WIRE COLOR
OF FIXTURE ,NEVER CONNECT WIRE TO GROUND WIRE
Connect ground wire according to below chart Connect wires according to below chart
Twist plastic wire connector until wires are tightly joined together,wrap each connector with approved electrical
tape.Be sure that no wire strands are exposed and then carefully tuck all wires into the outlet box .
Step C7: Raise canopy (E) to ceiling and secure canopy (H) in place by tightening threaded ring (F) onto collar loop (G).
Step C8: Install bulbs (not included) (Please do not exceed the maximum capacity recommended on the socket.)
5. Check everything is already installed properly, then you could turn on the light. Enjoy!
CLEANING.
To clean, wipe fixture with a soft cloth. Do not use abrasive materials such as scouring pads or powders, steel wool
or abrasive paper.
ORDERING PARTS.
Keep this sheet for future reference, and in case you need to order replacement parts. All parts for this fixture can
be ordered from place of purchase. Be sure to use exact wording from illustration when ordering parts.