Instructions / Assembly

Page: - 4 - / 4
Raise canopy (E) to the ceiling and secure canopy (E) in
place by tightening cap nut (G) onto the pre-assembled
threaded nipple on single bar (C).
Check that everything is installed properly, then you can
turn on the light. We hope you enjoy your new lighting!
6 »
NOTE: The canopy (E) should be snug against the
ceiling and cap nut (G).
If not, adjust the threaded length of the
preassembled threaded nipple on single bar (C):
• first, unscrew the pre- assembled hex nut;
• then, screw the pre- assembled threaded nipple in
or out of single bar (C);
• when the secure length is achieved, tighten the
pre-assembled hex nut and back to step 6.
7 »
ORDERING PARTS
Keep this sheet for future reference in case you need
to order replacement parts. All parts for this fixture can
be ordered from the place of purchase. Be sure to use
exact wording from illustration when ordering parts.
CLEANING
To clean, wipe the fixture with a soft cloth. Clean glass
with a mild cleaner (such as mild and non-abrasive
soap). Do not use abrasive materials such as scouring
pads or powders, steel wool or abrasive paper.