Instructions / Assembly

Page: - 3 - / 4
Unscrew cap nut (G) from single bar (C).
Secure single bar (C) to the outlet box with mounting
screws (B).
Make wire connections
Connect wires as below wires connection shown. PLEASE NOTE THAT GROUND WIRE IS BARE COPPER
WIRE, NEVER CONNECT OTHER WIRES TO GROUND WIRES.
3 »
NOTE: the side of single bar (C) marked "GND" must
face out.
4 »
5 »
Twist wires together with plastic wire connectors until tightly joined, and wrap each connector with
approved electrical tape. Be sure that no wire strands are exposed and then carefully tuck all wires
into the outlet box.
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black without
tracer
Clear, Brown, Gold or Black with
tracer
Insulated wire(other than green)
with copper conductor
Insulated wire(other than green)
with silver conductor
* Note: When parallel wires (SPT I&
SPT ll) are used. The neutral wire is
square shaped or ridged and the
other wire will be round in shape or
smooth (see illus.)
OUTLET BOX
GROUND
DIMPLES
GREEN GROUND
SCREW
CUPPED
WASHER
FIXTURE
GROUND
Neutral Wire
GREEN GROUND
SCREW
OUTLET BOX
GROUND
FIXTURE
GROUND
Connect ground wires according to the below chart Connect wires according to the below chart
A B