Installation Guide

[phone] Working hours : Mon - Fri 9:00 a.m. - 16:00 p.m. EST [e-mail]
www.ihomeangel.com Page: - 3 - / 4
2) Carefully and gently pull the wires and fiberglass sleeve from the
another end of arm(F) ,meanwhile push the socket (G)till two parts
of joint are close each other , lay wires in the cave of joint(E), then
proceed to push till the two parts are put together, secure
with the stud.
Do the same to the middle joint and base joint to finish the arms
assembled
4. Make fixtue assembly
1) Carefully pass the wires from outlet box through the
mounting plate(A) ,then attach the mounting plate (A) to
outlet box with mounting screws
Note :the screws of mounting plate(A)should be horizontal installation.If not,
rotate carefully the mounting plate side to side until the angle is achieved ,
tighten the mounting screws (M)
2) Make wire connections
Connect wires as below wires connecting shown. TAKE NOTE OF YOUR WIRE COLOR OF FIXTURE ,NEVER CONNECT
WIRE TO GROUND WIRE
Connect ground wire according to below chart Connect wires according to below chart
Twist plastic wire connector until wires are tightly joined together,wrap each connector with approved electrical tape
for more secure connection and carefully tuck all wires into the outlet box
3) Put the back plate (C)onto the screws of mounting plate (A)and secure
with ball nuts (K)