Instructions / Assembly

[e-mail]
Page: - 3 - / 4
Step A1: Pass the power cord through the hole in back plate
Step A2: Make the strain relief knot:
1. Place a pair of wires to be parallel
2. Twist backward the left of wire to make a circle
3. Twist backward the right of wire over the left wire to be an arc then pass it through the first circle ,
gently pull the ends of wires till the knot is snug.
Step A3:Connect wires as below wires connecting shown. TAKE NOTE OF YOUR WIRE COLOR OF
FIXTURE ,NEVER CONNECT WIRE TO GROUND WIRE .
Twist plastic wire connector until wires are tightly joined together,wrap each connector with
approved electrical tape for more secure connection .
3. Make fixture installation
1) Remove and discard the preassembled ground screw(B) from the
mounting plate (A).
2) By measuring, determine the correct distance between holes needed for
proper drilling hole. Use the driller to make two holes for knocking anchor (N)into
the wall , then attach the mounting plate (A) to the wall with
wood screws(O),