Installation Guide

www.ihomeangel.com Page: - 3 - / 4
2) Make wire connections
Connect wires as below wires connecting shown. TAKE NOTE OF YOUR WIRE COLOR OF FIXTURE ,NEVER CONNECT
WIRE TO GROUND WIRE
Connect ground wire according to below chart Connect wires according to below chart
Twist plastic wire connector until wires are tightly joined together,wrap each connector with approved electrical tape and
carefully tuck all wires into the outlet box
3) Push back plate (E)to wall,carefully passing moungting
screws through holes in back plate(E),pass the gaskets(F)over the nipple
and then tighten ballk nobs (G)to secure back plate (E)in place
Note: The backplate (E) should be snug against the wall
and the ball knobs. If not, adjust the length of the nipples
on the mounting plate assembly (A) by unscrewing the
preassembled hex nuts and then screwing the mounting screws
in or out of the mounting plate until the length is achieved.
Tighten the hex nuts and proceed to “step 3)”
4) Install bulb (Not included. Please do not exceed the
maximum capacity recommended on the socket.)
[phone] Working hours : Mon - Fri 9:00 a.m. - 16:00 p.m. EST [e-mail]