Installation Guide

Page: - 4 - / 4
Step B1:Unscrew the ball nut (F) from canopy (E)then gently remove the moungting plate (B)
Step B2:Attach the mounting plate (B) to outlet box with mounting screws (D)
Step B3: Make wire connections
Connect wires as below wires connecting shown. TAKE NOTE OF YOUR COLOR OF FIXTURE ,NEVER CONNECT
WIRES TO GROUND WIRES
Connect ground wire according to below chart Connect wires according to below chart
Twist plastic wire connector until wires are tightly joined together,wrap each connector with approved electrical tape
for more secure connection and carefully stuff all wires into the outlet box
Step B4: Raise canopy (E) to ceiling and secure canopy (E) in place by tightening ball nuts (F) onto screws
Step B5: Install bulb (Not included. Please do not exceed the maximum capacity recommended on the socket.)
5. Check everything installed properly, then you could turn on the light.
CLEANING
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as
scouring pads or powders, steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order replacement parts. All parts for this fixture can
be ordered from place of purchase. Be sure to use exact wording from illustration when ordering parts.
[phone] Working hours : Mon - Fri 9:00 a.m. - 16:00 p.m. EST [e-mail]
www.ihomeangel.com