Installation Guide

Page: - 3 - / 4
Step A1: Carefully place glass (K) into the fixture frame (J). At this point, the glass has two different sizes, the bigger end of
glass must be faced down.
Step A2: Attach the protection pad (L) to clip (M)
Step A3: Place the clips (M) to the threaded holes at the bottom of fixture frame (J), then secure with screws (N)
Step A4:
By measuring, determine the correct number of links needed for proper hanging height. Using the chain pliers,
disconnect and discard the remaining chain.
Step A5: Attach a quick link(H) to loop ( G)on the top of fixture and to connect the end of chain(I).Do the same with the
another end
Step A6: Gently lace wires through chain (I) , loop(G) to the top of mounting plate ( B)
Step A7: If needed, cut off the wires length of fixture.At this point,need take note of length should be available
for the following mounting.the length from the top of nipple are at least 6"
4. Make installation
[phone] Working hours : Mon - Fri 9:00 a.m. - 16:00 p.m. EST [e-mail]
www.ihomeangel.com