User's Manual

AT Command Manual v1.3
@2010 LM- Technologies Ltd www.lm-technologies.com Page 6 of 18
2.7 Command Types
Command Type Parameter Command
Device Information Test AT
Firmware Version AT+VER
Settings AT+ENQ
Reset Restore Factory
Settings
AT+RESET
Serial Port Baud Rate AT+BAUD
Stop Bits AT+STOP
Parity bits AT+PAR
Flow Control AT+FLOW
Character Echo AT+ECHO
Command Response AT+RESP
Modem Signal AT+MODEM
Bluetooth Type Device Role AT+ROLE
Information BD Address AT+ADDR
Inquire devices AT+FIND
RSSI AT+RSSI
Settings Device Name AT+NAME
Security AT+PIN
Discoverability AT+DCOV
Connection Connect inquired
device
AT+CONN
Drop connection AT+DROP
Bonding AT+BOND
Auto Connect AT+ACON
Misc Escape Sequence +++
Escape Sequence
handling
AT+ESC
Mode switch AT+AUTO
Remote Configuration AT+RCFG
Low power Mode AT+SLEEP
2.8 Command Description
2.8.1 AT
This command allows the connected host device to check the availability of the Bluetooth device.
The connected host device must have same serial port settings as configured for the Bluetooth
device.
2.8.1.1 Syntax
AT<cr>