User's Manual

AT Command Manual v1.3
@2010 LM- Technologies Ltd www.lm-technologies.com Page 10 of 18
c Echo back
‘+’ Enable
‘-‘ Disable
2.8.9.1.1 Response
<command_response>
2.8.9.2 AT+ECHO?<cr>
2.8.9.2.1 Response
<cr,lf>ECHOc<command_response> if the command is successful. Here, c- current
echo back setting. E.g on default setup, the response will be
<cr,lf>ECHO+<command_response>
2.8.10 AT+RESP
The command is used to enable/disable the command response from the Bluetooth device. Different
types of command response may be received by Host device and are listed in
Command Response
.
The current setting can also be retrieved by sending this command in query format.
2.8.10.1 AT+RESPc<cr>
Where parameter c is a character used to enable/disable the command response.
c Command Response
‘+’ Enable
‘-‘ Disable
2.8.10.1.1 Response
<command_response>
2.8.10.2 AT+RESP?<cr>
2.8.10.2.1 Response
<cr,lf>RESPc<command_response> if the command is successful. Here, c- current
command response setting. E.g on default setup, the response will be
<cr,lf>RESP+<command_response>
2.8.11 AT+MODEM
This command is available only for v6.5x firmware. This is the default firmware in LM048v2 and
LM058v2 adapters. This command is used in conjunction with AT+FLOW command to enable/disable
various RS232/Modem Signals. The current setting can also be retrieved by sending this command in
query format.
2.8.11.1 AT+MODEMc<cr>
Where parameter c is used to disable or configure Local Loopback or Remote Transfer
settings on the adapter
C Modem Signals
‘-’ Disable
‘L‘ Local Loopback
‘R’ Remote Transfer