User's Manual

LM505-M Page 2 of 3
[phone] | www.lm-technologies.com | [e-mail]
3 Packaging Options
4 General Specification
Product: LM505 Module
Part No: 505-0513
Datasheet Rev 1.0/25-07-12
1x Bluetooth USB Module
Tape and Reel or Tray
Part No 505-0513
Specificaon
Descripon
Product Name LM505 Bluetooth HCI USB Module
Chipset Broadcom BCM2046
Bluetooth Standard
Bluetooth v2.1 + EDR
Frequency Band 2.4 - 2.4835 GHz ISM Band
Modulaon Method
GFSK for 1 Mbps, π/4-DQPSK for 2 Mbps, 8-DPSK for 3 Mbps
Spread Spectrum
FHSS (Frequency Hopping Spread Spectrum)
Transfer Rate (Max)
3 Mbps enhanced data rate
RF Output Power
Class 2
Working Distance 10 m - 25 m in open space
Rx Sensivity
-80 dBm at 0.1 % BER
Input Voltage DC 5V (via USB interface)
I/O Interface
USB 2.0
LED indicator
Power/Acve
OS Support
Embedded Linux or WinCE with Bluetooth Stack support
Size 19.7 (L) x 10(W)
Soware/Drivers Linux BlueZ, Windows CE, Windows Mobile Bluetooth Driver
Bluetooth Profiles GAP,SPP,HSP, HFP, DUN, FTP, FAX, PAN, LAN, HID, SYNC, HCRP, A2DP, AVRCP,
BIP, GOEP, SDAP, OPP
5 FCC Warning Statement
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operaon.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a residenal
installaon. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instrucons, may cause harmful interference to radio communicaons. However, there is no guarantee that interference
will not occur in a parcular installaon. If this equipment does cause harmful interference to radio or television recepon,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separaon between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modificaons to this unit not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.