User's Guide

© Copyright LM Technologies Ltd Page 38 of 70
www.lm-technologies.com
LM074 SPP with GAP Central Application v1.1
4.2.10 “AT*SETTINGS”\r\n
i. Query only command
ii. Module settings query: “AT*SETTINGS=?”\r\n
iii. Report for “AT*SETTINGS=?” command is multiple line, at the end
of the report a message “REP*:SETTINGS=END” is delivered.
iv. Module settings query report varies according to DPIN setting. If
DPIN is OFF i.e. supporting to BT2.0, Module PIN is displayed. If
DPI is ON, i.e. support to BT2.1, then settings for IO-capability,
MITM are displayed.
“AT*Settings” report
when
DPIN is OFF
“AT*Settings” report
when
DPIN is ON
at*settings=?at*settings=?
OK
NAME=
LM074
_SPP+GAPCEN
_010
6
ADDR=0002
-5b-00a5a5
PAIR=ON
DCOV=ON
BAUD=19200(2)
STOP=Stop_One(0)
PARITY=None(0)
FLOW=OFF
SPPRole=SLAVE ACON=OFF
BOND=0000
-00-000000
DPIN=OFF
PIN=1234
GAP_ENABLE=OFF
VER=
074
LM_GAPCEN_01.06
REP*:SETTINGS=END
OR
at*settings=?at*settings=?
OK
NAME=
LM074
_SPP+GAPCEN
_010
6
ADDR=0002
-5b-00a5a5
PAIR=ON
DCOV=ON
BAUD=19200(2)
STOP=Stop_One(0)
PARITY=None(0)
FLOW=OFF
SPPRole=SLAVE
at*settings=?at*settings=?
OK
NAME=
LM074
_SPP+GAPCEN
_010
6
ADDR=0002
-5b-00a5a5
PAIR=ON
DCOV=ON
BAUD=19200(2)
STOP=Stop_One(0)
PARITY=None(0)
FLOW=OFF
SPPRole=SLAVE
ACON=OFF
BOND=0000
-00-000000
DPIN=ON
MITM=OFF
IOTYPE=NO_InOut
GAP_ENABLE=OFF
VER=
074
LM_GAPCEN_01.06
REP*:SETTINGS=END
OR
at*settings=?at*settings=?
OK
NAME=
LM074
_SPP+GAPCEN
_010
6
ADDR=0002
-5b-00a5a5
PAIR=ON
DCOV=ON
BAUD=19200(2)
STOP=Stop_One(0)
PARITY=None(0)