User's Guide

© Copyright LM Technologies Ltd Page 12 of 70
www.lm-technologies.com
LM074 SPP with GAP Central Application v1.1
ERR
at*enbgap=onat*enbgap=on
OK
Module soft-Reset..SPP+GapCentral_Message_Loop
GATT Initialised
REP*:LESEC=Success
at*settings=?at*settings=?
OK
NAME=LM074_GAP_Central
ADDR=0002-5b-00a5a5
FLOW=OFF
SPPRole=SLAVE
ACON=OFF
BOND=0000-00-000000
DPIN=OFF
PIN=1234
GAP_ENABLE=ON
LE_SEC=OFF
LE_AUTO_SCAN=ON
VER=074LM_GAPCEN_01.06
REP*:SETTINGS=END
at*enbgap=?at*enbgap=?
OK
REP*:GAP_ENABLE=ON
at*enbgap=onat*enbgap=on
ERR
at*enbgap=offat*enbgap=off
OK
Module soft-Reset..SPP+GapCentral_Message_Loop
3.3 BLE discovery commands:
3.3.1 “AT*LEFIND”\r\n
i. Execution only command.
ii. To begin discovery of nearby BLE peripheral devices, use the
command “AT*LEFIND=ON”\r\n
iii. The module responds with OK to this command if it is not already
scanning the devices, otherwise it responds as “ERR”.