Manual
DISASSEMBLY OF THE LLAMA MODEL MINIMAX SUBCOMPACT – CAL. .45
The LLAMA pistol is quite easily taken apart. The parts mentioned in the following instructions
refer to those described and illustrated in the schematic.
1. Press the magazine catch (T 304) with your left thumb and take out the magazine (T 708).
2. Pull back the slide (T 701) until its slide stop notch is opposite the prolongation or nose of
the slide stop (T 709). Once in this position, press on the slide stop (T 709) pin from the
right hand side of the frame until disassembly is complete. For that purpose, it is
necessary to overcome the pressure of the slide stop plunger (D 153) spring.
3. Move the slide (T 701) forward in order to disengage the barrel (T703), the recoil spring
guide (D 607), the external recoil spring (D 609), the spring plug (D 610) and the slide (T
701)
from the frame (T 700).
4. Holding the head of the recoil spring guide
(D 607), and pulling it outwards, it can be
removed from the slide
(T 701) together with its recoil springs (D 609). Then, remove the
recoil spring plug (D 610) from its housing in the slide. After that, the barrel (T 703) is
withdrawn from its housing in the slide (T 701) by pulling it forward.
5. The grips (D 620) (D 621) are disassembled with a simple screw-driver. Clean the pistol
with a brush, using a cleaning agent and grease the parts lightly. Do not proceed with the
disassembly.
ASSEMBLY OF THE LLAMA MODEL MINIMAX SUBCOMPACT – CAL. .45
1. Insert the barrel (T 703) in its housing in the slide (T 701). Insert the recoil spring plug (D
610).
Fit the recoil spring guide (D 607), with the springs (D 609), and introduce this
assembly inside its housing in the recoil spring plug (D 610). It will be properly fitted
when it is housed in the pipe-shaped front part of the barrel (T 703).
2. Holding the part assembly mounted on the slide (T 701) with one hand, and the frame (T
700)
with the other hand, assemble these together, sliding them along the frame (T 700)
guides until the barrel (T 703) attachment hole is placed in front of the hole of the slide
stop (T 709) housing located in the frame (T 700). Insert the pin of the slide stop (T 709)
into its housing. When placing the slide (T 701) in the frame (T 700), try to prevent the
firing pin safety disconnector
(D 199) from protruding over the frame’s (T 700) flat upper
surface. To do this, push it downward, attempting not to touch the grip safety (D 507)
until the slide (T701) is mounted.
3. Push the slide
(T 701) backwards, until the housing for the slide stop (T 709) in the frame
(T 700), is placed in front of the housing with the same reference (T 709) in the slide (T
701)
. Once both references are placed in the suitable position, push the slide stop (T 709)
with your thumb until it is placed in its housing, overcoming the spring pressure of the
slide stop plunger (D 153).
4. Check that the slide-barrel sub-assembly slides smoothly on the frame
(T 700). Insert the
magazine (T 708) again. The weapon is ready to use.
FABRINOR – P.O. Box 290- 01080 VITORIA (Spain)
IMPORTANT When ordering list Code Number, Part Name, Caliber, Model and Serial Number.