Manual

Automatgevär m/42 B Manual

2000 Anders & Petter.

The sight and the sight base have alignment marks. When the rifle is sighted in, these two should normally

be lined up with each other.

If windage needs to be adjusted, proceed as follows;

Release the muzzle plug 3-4 turns.

Using the universal tool, turn the front sight screw right (left) if point of impact is to be moved to the right

(left). I full turn of the screw equals 8,5 cm at 100 m distance. Note that the screw has some play. Count the

turns from where the screw starts to pull.

Elevation is set to achieve a point of impact 10 cm above point of aim at 100 m. Elevation adjustments

should only be carried out by an armourer.

6. Bayonet

The bayonet is attached to the rifle by placing the handle over the cleaning rod and the ring over the

muzzle. Then push it down until it locks.. To remove the bayonet, pull out the lock button and lift it off.

7. Blank firing device

The blank firing device must be used when shooting blank ammunition.