Manual

Automatgevär m/42 B Manual

2000 Anders & Petter.

3. Assembly

The extractor is installed in the bolt as follows;

Place the extractors lower inside edge on the pinhead. Note that the head should not be placed in the cut on

the underside of the extractor.

Push the extractor straight down (compress the spring) until it is lined up with it’s slot in the bolt.

Still holding it down, push it in until the pin slides into it’s position.

The firing pin is inserted into the bolt with the flat surface positioned so that the retaining pin can be

inserted.

Aided by the picture above, assemble the bolt and bolt carrier.

Insert the bolt assembly into the receiver, as far as it goes. If the magazine has not been removed the

follower must be pushed down while doing this.

Fit the cover and push it forward until it locks to the bolt carrier. To avoid damage to the recoil spring and

rod make sure that they are properly guided into the slot in the carrier.

Hold the safety lever pointing straight rearwards, insert the receiver cap (safety assembly) and turn the

safety to the left.

Hold the cover. Push in the locking latch and slowly release the cover.

Release the trigger and turn the safety on.

Insert the magazine.