Data Sheet

LJ1269HC
Rev1.0 Page 74 Web: www.ljelect.com
7.2.2. Manual Reset
A manual reset of the LJ1269HC is possible even for applications in which VDD cannot be physically disconnected. Pin RESET
should be pulled high for a hundred microseconds, and then released. The user should then wait for 5 ms before using the
module.
Figure 39. Manual Reset Timing Diagram
Note whilst pin RESET is driven high, an over current consumption of up to ten milliamps can be seen on VDD.
Sub GHz FSK/OOK Transceiver Module DATASHEET