Installation Sheet

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT#5631 8014
For Ceiling Mount Fixtures
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old
fixture and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Thread the two Studs about 1/4”into the pre-drilled holes in
the mounting plate spaced the same distance apart as the
holes in the plate (A).
4. Attach the mounting plate to the Junction Box with the two
Junction Box Screws as shown. The side of the mounting
plate marked "GND" must face out. The junction box is not
included.
5. While holding the plate(A) assembly towards the ceiling,
connect the electrical wires as Shown in Fig.2, making
sure that all wire nuts are secured. You may have to wrap
the connections with electrical tape. If your outlet has a
ground wire (green or bare copper), connect the fixture
ground wire to it. Otherwise connect fixture’s ground
wire directly to the Mounting strap with the green screw
provided. After wires are connected, tuck them carefully
inside the Junction Box.
6. Raise the plate (A) onto the junction box, aligning screws
on mounting plate with mounting holes in plate (A) and
lock it securely with the ball nut (C).
7. Install the light bulbs in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE
SPECIFIED WATTAGE.
8. Slide the hook (B) to right until becoming, then raise
glass(D) into the hooks.
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1
B
C
D
A
Green
Fig.2
MIN 90℃ SUPPLY CONDUCTORS
DOC20141205631
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE