Installation Guide

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT# 2116 2113 2106
OUTDOOR CEILING LIGHT FIXTURE
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
Fig.1
ASSEMBLING THE FIXTURE (Fig.2).
1. Install the light bulbs in accordance with the fixture
specifications NOTE: DO NOT EXCEED THE SPECIFIED
WATTAGE!
HANGING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove old fixture
from ceiling, including the old single bar.
2. Carefully unpack new fixture and lay all the parts
on a clear
surface.
3. Th
read nipple (C) into loop (F) until snug
.
4. Threa
d other end of nipple (C) with loop attached into single bar
(D) until snug
.
5. Place lock washer (B) over end of nipple protruding through single
b
ar and thread hex nut (A) onto nipple until tight
.
6. T
ake this single bar assembly and mount to ceiling junction box
with junction box screws (E). Tighten screws securely with
screw
driver.
7. Using proper chain pliers to open one end link of the chain
provided and connect to the fixture loop (I). Close the link
.
8. B
y measuring, determine correct number of links needed for
proper hanging height. Using proper chain pliers disconnect and
discard remaining chain.
9. Lace the fixture wires through the chai
n.
10
. Slip loop collar (H) over the chain, then do the same with th
e
can
opy (G).
11. Open the other end link of the chain and hang the fixture on the
loop at the ceiling. Close the li
nk.
12
. Feed the fixture wires through the loop (F) and nipple (C) and pu
ll
until taut.
13
. Slide canopy (G) up flush to ceiling, secure using loop collar(H)
.
CONNECTING THE WIRES (Fig.3)
1. Take the black wire from the ceiling junction box and the smooth
wire leg from the fixture and twist bare ends together. Twis
t wire
co
nnector onto end of wire until snug
.
2. Repeat same process with white junction box wire and ribbed wire
leg of fixture wire. NOTE: Twist wires together in the same
direction you twist the wire connector onto
wires.
3
. If your junction box has a grounding wire (green or bare copper)
,
attach this wire and the
bare copper wire from the fixture together
as step 1.If junction box has no ground wire, attach the bare copper
fixture wire to the green ground screw on the single bar.
4. Tuck these wire connections neatly into the ceiling outlet box
and
th
en raise the canopy (G) all the way to the ceiling. Raise th
e loop
(H) an
d thread onto ceiling loop protruding through canopy
.
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.2
Fig.3
:KLWHRU
+286(
%ODFN
:,5(6
+RW
6PRRWK
),;785(
:,5(6
%ODFNRU
5LEEHG
:,5(6
),;785(
%DUH&RSSHU*URXQG
),;785(
:,5(6
&RSSHU
*URXQG
+286(
1HXWUDO
:,5(6
:KLWH
%DUH
*UHHQRU
:,5(6
+286(

DOC20141202116
(Not included)